Welcome to LEAD Support Forum Login | Register | Faq  

    LEAD Support Forum
  Resource to find answers and post technical questions about LEAD products.
Search    
   

How to set secondary video input for LEAD Video Overlay Filter
Started by twhif at 12-30-2007 19:03. Topic has 2 replies.

Print Search « Previous Thread Next Thread »
  12-30-2007, 19:03
twhif is not online. Last active: 3/7/2008 1:39:39 PM twhif

Top 500 Posts
Joined on 12-30-2007
Posts 9
How to set secondary video input for LEAD Video Overlay Filter
Reply Quote
The LEAD Video Overlay Filter doc suggests that 2 input videos can be layered onto the output video stream. However, I can't figure out how to specify the source of the secondary video input. The doc says to connect the second video stream to pin 1 of the filter but I'm not sure what that means.

I can configure the video1 layer and the overlayimage layer as needed but not the video2 layer. Can someone please tell me how this is done or point me to a relevant sample?

   Report 
  12-31-2007, 9:00
Adnan Ismail is not online. Last active: 9/4/2008 2:25:00 PM Adnan Ismail



Top 10 Posts
Joined on 07-31-2006
Posts 1,150
Re: How to set secondary video input for LEAD Video Overlay Filter
Reply Quote
Unfortunately, this is not possible with our toolkit. You need to use Video Overlay filter in low-level DirectShow to add the second video layer.
Adnan Ismail
LEADTOOLS Technical Support

   Report 
  01-01-2008, 10:12
twhif is not online. Last active: 3/7/2008 1:39:39 PM twhif

Top 500 Posts
Joined on 12-30-2007
Posts 9
Re: How to set secondary video input for LEAD Video Overlay Filter
Reply Quote
That's too bad, it might have saved me a lot of work. Thanks for your reply.
   Report 
Post
LEAD Support Fo... » Developer » Multimedia Filt... » How to set secondary video input for LEAD Video Overlay Filter

Powered by Community Server, by Telligent Systems