Welcome to LEAD Support Forum Login | Register | Faq  

    LEAD Support Forum
  Resource to find answers and post technical questions about LEAD products.
Search    
   

Re: How to set secondary video input for LEAD Video Overlay Filter
Started by twhif at 12-30-2007 19:03. Topic has 2 replies.

Print Search « Previous Thread Next Thread »
  12-30-2007, 19:03
twhif is not online. Last active: 3/7/2008 1:39:39 PM twhif

Top 500 Posts
Joined on 12-30-2007
Posts 9
How to set secondary video input for LEAD Video Overlay Filter
Reply Quote
The LEAD Video Overlay Filter doc suggests that 2 input videos can be layered onto the output video stream. However, I can't figure out how to specify the source of the secondary video input. The doc says to connect the second video stream to pin 1 of the filter but I'm not sure what that means.

I can configure the video1 layer and the overlayimage layer as needed but not the video2 layer. Can someone please tell me how this is done or point me to a relevant sample?

   Report 
  12-31-2007, 9:00
Adnan Ismail is not online. Last active: 8/14/2008 1:40:07 PM Adnan Ismail



Top 10 Posts
Joined on 07-31-2006
Posts 1,124
Re: How to set secondary video input for LEAD Video Overlay Filter
Reply Quote
Unfortunately, this is not possible with our toolkit. You need to use Video Overlay filter in low-level DirectShow to add the second video layer.
Adnan Ismail
LEADTOOLS Technical Support

   Report 
  01-01-2008, 10:12
twhif is not online. Last active: 3/7/2008 1:39:39 PM twhif

Top 500 Posts
Joined on 12-30-2007
Posts 9
Re: How to set secondary video input for LEAD Video Overlay Filter
Reply Quote
That's too bad, it might have saved me a lot of work. Thanks for your reply.
   Report 
Post
LEAD Support Fo... » Developer » Multimedia Filt... » Re: How to set secondary video input for LEAD Video Overlay Filter

Powered by Community Server, by Telligent Systems